These 1967-68 Recaro buckets seats have undergone a full restoration. The seats had two holes that had been cut out for lap belts, a few holes drilled in the sides, as well as a small crack at the top of both seats; all of which were properly repaired. Below are photos of the restoration process.
Holes that were drilled in the sides.
Factory tilt bracket.
Original foam.
Original part number.
Original part number.
Headrest support brackets.
Disassembled and ready for repairs.
Holes that were cut for lap belts.
Tapered around the edges of the holes for good fiberglass adhesion.
Tapered around edges of crack to ensure proper fiberglass adhesion.
Also tapered around the holes.
Fiberglass properly applied.
The preparation process of grinding and tapering is done to the inside of all areas needing repair, prior to application of the fiberglass.
Fiberglass work is finished, and the seats are now ready for paint.
